Troubles detecting nodes propperly (Fibaro Motion)
Posted: Saturday 02 April 2016 17:32
I'm moving my setup to another clean Raspberry pi 3 installation.
I moved my Aeonlabs usb stick to the new device, but not all device are being detected.
i've waited around 24 hours to see if the devices needed to wake up or something, but nothing happened.
I even tried to force some motion sensors to "wake-up" by 3 times tapping the button inside them. Nothing is helping.
Hoe do i proceed from here. I prefer to keep the device "configuration" as is.
I moved my Aeonlabs usb stick to the new device, but not all device are being detected.
i've waited around 24 hours to see if the devices needed to wake up or something, but nothing happened.
I even tried to force some motion sensors to "wake-up" by 3 times tapping the button inside them. Nothing is helping.
Hoe do i proceed from here. I prefer to keep the device "configuration" as is.