Event script block learning new devices
Posted: Sunday 06 March 2016 22:10
I have created a few new events, partly in LUA and some in Blockly, just for the purpose of learning how this works.
Among others, I ping my and my wife's phone to determine if there is someone home, and switch a light.
This works fine, but then I went back to set up all my KAKU switches and sensors.
Learning a new switch no longer works! After the blue popup, I almost immediately see an error message saying that the signal is already in use.
I then disabled all of the events and tried again: I can now pick up the signal and store it as device.
Am I forgetting something?
If not, is there a way to temporarily disable all events, during the learning cycle?
Hans
Among others, I ping my and my wife's phone to determine if there is someone home, and switch a light.
This works fine, but then I went back to set up all my KAKU switches and sensors.
Learning a new switch no longer works! After the blue popup, I almost immediately see an error message saying that the signal is already in use.
I then disabled all of the events and tried again: I can now pick up the signal and store it as device.
Am I forgetting something?
If not, is there a way to temporarily disable all events, during the learning cycle?
Hans