Domoticz

Posted: **Wednesday 17 February 2016 14:48**

I have a Conrad wall receiver RSLU 1-channel and
a wall switch RSLT2 2-channel,
With the wall switch I can control the wall receiver
With the RFLink I can detect the wall switch in Domoticz
But I´m unable to control the wall receiver with in Domoticz
In the log file I can see the message

Code: Select all

“RFLink Sending: 10;Conrad;acc500;5;ON”

But noting is happening.
When I try to send it direct to the Rflink in Putty

Code: Select all

RFLink Sending: 10;Conrad;acc500;5;ON

There is a error in the log0file

Code: Select all

Error: RFLink: Error/Unknown command received!....

How can I find the a solution

Posted: **Wednesday 17 February 2016 17:05**

See PM..

Posted: **Saturday 05 March 2016 16:56**

Hi Stuntteam,

I have exactly the same problem. I can receive the signals send from the wall switches in domoticz but cant send this codes to the wall receiver from domoticz. I bought a RSLU1 receiver and a RSL4 sender/receiver kit. And some RSLT3 senders. I'm running domoticz on a raspberry pi 2 wich is connected with RFLink Gateway. Both RSLU1 and RSL4 receivers are not reacting on domoticz signals.

Thank You in Advance

Posted: **Saturday 05 March 2016 19:09**

Send a mail to [email protected] for a test version

Domoticz

Can't controle Conrad wall receiver

Can't controle Conrad wall receiver

Re: Can't controle Conrad wall receiver

Re: Can't controle Conrad wall receiver

Re: Can't controle Conrad wall receiver