Aeotec Z-stick Gen5 and Fibaro FGMS0-001 - pain in the ....
Posted: Tuesday 02 February 2016 22:59
Hi,
I've been playing with Domoticz for 4 days and pull out my hair with proper config with Aeotec Z-stick Gen5 and Fibaro FGMS-001 multisensor on Raspberry Pi 2. After following http://www.domoticz.com/wiki/PersistentUSBDevices, Domoticz was able to see the z-stick properly. However including the FGMS-001 not working at all - error OpenZWave: Node Removed. HomeID: 3292086934, NodeID: 2 (0x02).
Initially I thought it's the issue with the sensor as I tried it with OpenHAB. But then I downloaded trial Indigo software on my iMac and all worked out of the the box with no issues at all.
Any suggestions/ideas?
Thanks,
Rafe
I've been playing with Domoticz for 4 days and pull out my hair with proper config with Aeotec Z-stick Gen5 and Fibaro FGMS-001 multisensor on Raspberry Pi 2. After following http://www.domoticz.com/wiki/PersistentUSBDevices, Domoticz was able to see the z-stick properly. However including the FGMS-001 not working at all - error OpenZWave: Node Removed. HomeID: 3292086934, NodeID: 2 (0x02).
Initially I thought it's the issue with the sensor as I tried it with OpenHAB. But then I downloaded trial Indigo software on my iMac and all worked out of the the box with no issues at all.
Any suggestions/ideas?
Thanks,
Rafe