Domoticz

I´m using an Aeon Labs Aeotec Z-Stick Gen5 and just irritated from the blue, yellow, red blinking of the status LEDs.
The manual says that this is the " normal" behavior that all is ok... But sorry, that is annoying, because when all is ok, it should not blink like an Disco

In another German forum ( but for another controller software ) i found that it is possible to get rid of this by sending this command to the controller:

get <ZWDONGLE> raw f2510100


But how can i fire that to my controller thru Domoticz ???

Good question, do you have an answer yet.
I installed the zstick today as an upgrade to my current zwave stick. I thought something was wrong because of the flashing leds

Er, you can control this directly from within Domoticz: