Domoticz

Code: Select all

startTempLet.sh  TempBroadLetto.sh  TempBroadLetto.txt  
startTempSal.sh  TempBroadSalone.sh  TempBroadSalone.txt

Code: Select all

#info: https://community.openhab.org/t/broadlink-black-bean-rm-3-mini-ir-controller-help-with-understanding-their-udp-protocol/11453/23

cd /home/pi/domoticz/scripts/python/
git clone https://github.com/davorf/BlackBeanControl.git


sudo nano BlackBeanControl/BlackBeanControl.ini 

Wireshark
tpacketcapture





There is BlackBeanControl.ini file which consists of General and Commands section. General section should contain: 
- IPAddress: IP address of the RM 3 mini device
- Port: Port of the RM 3 mini device - usually 80
- DummyCommand: Hex dump of the UDP payload that will be sent before every other command - it should be already learned IR command that is not used, for example, IR command from an old, unused remote control. RM 3 mini does not want to trigger commands if they are sent over UDP more then once consecutively, so, this command is used to bypass this problem

Commands section should contain list of command names (only letters, without blanks) followed by column and a hex dump of the actual command. For example:

TVVolumeUp: [HEX DUMP]
ACTempUp: [HEX DUMP]

A syntax for calling a script is:

BlackBeanControl -c [-i IP Address] [-p Port]

Command name parameter is the name of command already stored in an .ini file
IP Address and Port are optional parameters - used in case there is a need for sending UDP payload to a multiple RM 3 minis in the same network. If value is not assigned to these parameters, values from an .ini file will be used.

I'm not very friendly with java, so I'm not able to make this into regular OpenHAB binding - if that is possible at all. If someone is willing to do that, I'll help as much as I can.