Domoticz

ok. and did you change prefix zwave > zwavejs
not sure but I thought you need to reboot after that change
and domoticz settings must allow for new devices

what devices do you own? switches will appear in short time but measuring devices must first have seen a change of measured value

ok. and did you change prefix zwave > zwavejs

Where?

domoticz settings must allow for new devices

Done

what devices do you own?

Switches and measuring devices

prefix to be changed both in zwavejs as well as domoticz hardwarepage

Well I now get this

imho zwave2mqtt is now running as expected. And what is on zwavejs-ui control panel?

I have this

Looks like your nodes aren't discovered yet, so you first need to get ZWAVEJS2MQTT working properly, before you can do anything with domoticz.

Thanks for your help and patience.
How do I do that please

Have you setup the zwave part in ZWAVEJS2MQTT correctly, like the proper network keys?: https://zwave-js.github.io/zwave-js-ui/ ... ?id=z-wave.
.. and did you wake all devices up to ensure they tell the coordinator that they are there?

Yes I have set up the network keys. I did a hard reset on the z-wave controller and it now only lists this in Z-Wave JS UI
But when I try to include a device it doesn't work (I'm assuming I do this in Z-Wave JS UI)

keef wrote: ↑Tuesday 12 March 2024 18:10 Yes I have set up the network keys. I did a hard reset on the z-wave controller and it now only lists this in Z-Wave JS UI

Not sure why you've done that... but understand you decided to start all over again and want to include all devices again.

keef wrote: ↑Tuesday 12 March 2024 18:10 But when I try to include a device it doesn't work (I'm assuming I do this in Z-Wave JS UI)

This is indeed all ZWAVEJS2MQTT stuff. As mentioned, you will have to get all devices properly list in ZJS2M first before Domoticz will get the required config via Auto Discovery.

jvdz wrote: ↑Tuesday 12 March 2024 18:28

keef wrote: ↑Tuesday 12 March 2024 18:10 Yes I have set up the network keys. I did a hard reset on the z-wave controller and it now only lists this in Z-Wave JS UI

Not sure why you've done that... but understand you decided to start all over again and want to include all devices again.

Yep wanted a clean start

keef wrote: ↑Tuesday 12 March 2024 18:10 But when I try to include a device it doesn't work (I'm assuming I do this in Z-Wave JS UI)

jvdz wrote: ↑Tuesday 12 March 2024 18:28 This is indeed all ZWAVEJS2MQTT stuff. As mentioned, you will have to get all devices properly list in ZJS2M first before Domoticz will get the required config via Auto Discovery.

I have put the devce and Zwave-JS-UI in inclusion mode (I even reset the device (to make sure it wasn't being stupid) but it just times out.

which pi and which zwave stick are used?

It's a pi4 and a zwave.me USB Stick

did you use this stick before with OZW? Some sticks are not compatible with pi4.

yes it was working before

some sticks allow including just with stick near zwavedevice iso via zwavejs-ui. Is that possible for you?
And do you disable ozw in domoticz? Otherwise stick cannot be used in zwavejs.

I shall see if range is and issue.

No it is a fresh clean install

Nope range isn'the issue

did you unplug stick and include with stick near zwave device?