Domoticz

I did not quite understand what was going on? I'm just starting to deal with Node Red, and I know very little. It is possible in more detail where and what you need?

uh... that my severe fault!!!!!


mac addresses must be written without :
so if you eneterd aa:bb:cc:dd:ee the correct config is
aabbccddee

I apologize....

OK, I'll try. But it's not your fault, I don't know anything.

https://yadi.sk/i/zzryGpD2HNCtEA
https://yadi.sk/i/4PhTLPygjXmdCg
https://yadi.sk/i/NNAcrV1Tg3qwRw

Does not want to work

mmh looks like something happend...

the 2 telegrams oare the interface bringing up...

but you have to issue a

sudo systemctl daemon-reload

and then a reboot to be sure.... ( sudo reboot )

that should be hopefully enough

The sudo systemctl daemon-reload command has already been done, and it has disconnected everything that was superfluous, leaving one USB BLE at all. In the evening I will reboot the system and then we'll see.

https://yadi.sk/i/TCQJC1Mezb818g
I did everything, especially nothing has changed

IT WORKED

THANK

do some more battery checking

Anyone got the battery checking up and running. it keeps saying the nut is unavailable

It works. Got the wrong id for the check of the nut

Hey. I have a project on the malinka, it works, there is one USB bluetooth, how do I put the second one into error, can this be somehow fixed? Help is needed.

mh you do want to add a second interface?
if so you have to duplicate the script and configure for hci1 (assuming that hci0 is the onboard one)

Hi, no, I want to connect columns to the built-in hci0, how to configure the script on hci1?

And yet, once a day, it sometimes loses the mac address, and in a minute it finds again, is it possible to eliminate this error? Where to dig?