Unable to transmit signals (433Mhz and 2,4Ghz)

433Mhz opensource Receiver & Transmitter.

Moderators: leecollings, Stuntteam

Post Reply
dompi1524
Posts: 1
Joined: Wednesday 05 October 2016 13:16
Target OS: Raspberry Pi / ODroid
Domoticz version:
Contact:

Unable to transmit signals (433Mhz and 2,4Ghz)

Post by dompi1524 »

Hey,

i have received my rflink module from nodo-shop (433Mhz version) and tried to test it. i connected a NRF24L01+ module for milight support (i own 4 milight rgbw led controller + remote). i also own 4 mumbi m-fs300 plugs.

Domoticz recognizes everything but there is no reaction of the components when i try to transmit a signal.

In rflink loader i tried to debug. I tried to send the commands manually which works fine (i get OK respond from rflink) but theres no reaction from the components (light stays off)

any suggestions? is my rflink broken?
Attachments
Mumbi m-fs300.txt
mumbi debug log
(2.84 KiB) Downloaded 82 times
Milight.txt
milight debug log
(558 Bytes) Downloaded 85 times
User avatar
Stuntteam
Posts: 399
Joined: Wednesday 06 May 2015 16:39
Target OS: Raspberry Pi / ODroid
Domoticz version:
Contact:

Re: Unable to transmit signals (433Mhz and 2,4Ghz)

Post by Stuntteam »

Hi,

Contact [email protected] for support..
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic RFLink Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest