Reset/turn a switch/PIR off?

Topics (not sure which fora)
when not sure where to post, post here and mods will move it to right forum.

Moderators: leecollings, remb0

Post Reply
Calzor Suzay
Posts: 145
Joined: Tuesday 08 July 2014 15:10
Target OS: -
Domoticz version: 4.9700
Location: UK
Contact:

Reset/turn a switch/PIR off?

Post by Calzor Suzay »

Sometimes Domoticz doesn't always pick up a change in a door sensor or PIR etc.

I know this isn't Domoticz fault and down to the hardware and these things happen etc. I played with positioning etc. etc. but looking for an override so for example a magnetic door sensor says it's 'open' but quite clearly the door isn't and the I'm closed signal was never received or a PIR sensor that was detecting movement and Domoticz never sees the 'off' signal sent is there way to override this?

At the moment to counter this I tend to have go trigger the sensor so Domoticz sees the open then closed signal but I can't do this if I'm away etc. and the neighbours have brought my mail in or whatever.
annieoroberts00
Posts: 5
Joined: Tuesday 05 July 2016 8:36
Target OS: Windows
Domoticz version:
Contact:

Re: Reset/turn a switch/PIR off?

Post by annieoroberts00 »

Apparently because of the layout of the electrics in our house it wasn't really practical to rewire the kitchen light on its own - in the future when the rest of the house is done I guess it will be sorted out properly...I do have a new MCB, all beautifully labelled - these circuits are right next to each other in there so probably not as bad as it could be.
Calzor Suzay
Posts: 145
Joined: Tuesday 08 July 2014 15:10
Target OS: -
Domoticz version: 4.9700
Location: UK
Contact:

Re: Reset/turn a switch/PIR off?

Post by Calzor Suzay »

Eh wrong thread?
User avatar
bbqkees
Posts: 407
Joined: Sunday 17 August 2014 21:01
Target OS: Linux
Domoticz version: 4.1x
Location: The Netherlands
Contact:

Re: Reset/turn a switch/PIR off?

Post by bbqkees »

use a simple Blockly with the following logic:

IF SENSOR-A = ON, SET SENSOR-A = OFF after X seconds.
Bosch / Nefit / Buderus / Junkers / Worcester / Sieger EMS bus Wi-Fi MQTT Gateway and interface boards: https://bbqkees-electronics.nl/
Calzor Suzay
Posts: 145
Joined: Tuesday 08 July 2014 15:10
Target OS: -
Domoticz version: 4.9700
Location: UK
Contact:

Re: Reset/turn a switch/PIR off?

Post by Calzor Suzay »

I didn't realize you could directly effect the state of a PIR/Sensor etc. I'll try it.
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests