X10 using RFXtrx433

[cmacd]

I hope someone can advise. Please excuse my ignorance if this has been asked previously, but I couldn't find anything.

I have a mixture of x10 and LightwaveRf components in the house and recently added RFXtrx433 to system to control both via Domoticz. The LightwaveRf is all working fine including dimmers, however the x10 dimmers will only switch on and off, there is a slider on dashboard but it is greyed out. Is there a way to resolve or is it a limitation of this combination.

Additionally is it possible to control x10 robocam ptz units with this set up.


many thanks

Campbell

[b_weijenberg]

X10 set dim level is not supported in RF. The RFXtrx433E is able to transmit dim/bright commands but I don't if this is implemented in Domoticz.
A point of attention: the X10 RF commands are much faster than the X10 power line. X10 RF commands must not be transmitted too fast otherwise commands are lost.

The X10 robocam is supported in Type2 firmware. I don't think it is supported by Domoticz.