How to combine separate codes for a blind into one blind swi

[cherowley]

Hi!

My rf projector screen remote sends the following codes:

Up: Type=EV1527 ID=0000D4AD Unit=2
Stop: Type=EV1527 ID=0000D4AD Unit=8
Down: Type=EV1527 ID=0000D4AD Unit=4

So as a result when learning the remote in domoticz i end up with 3 separate switches.

How can i combine them into one blind switch (was thinking of the venetian eu blind switch)?

Can you set domoticz to transmit different codes for each action on the same switch?

Cheers!

[nigels0]

Its a good point. If you use a blind with up/stop/down then you can put the up and down commands in the on action and off action fields - but there is nothing there for stop. Suggest you either augment with a lua script or request a new feature in a future version.

Check out http://www.domoticz.com/forum/viewtopic.php?f=38&t=3360