New setup - Cannot include

[sanderl]

first: sorry for double posting. This question I also asked in aother thread with apparently the same issue.

Hi, I am new to Domoticz and can't "include" or "Receive information from other controller". I think I have everything in place. I am well known and familiar with Vera (started with Vera 1 with UI2).

I have: A synology NAS running the Domoticz package from jumbotroll (V2.4020) and succesfully have a "zwave plus" USB dongle from WD (smart home stick) running as device 001 with "OpenZWave USB
Version: 1.3-614-gadf3467". Controller status is "green".

Now when I try to include a node the message "Including ZWave Node - Press the include button on your device..." runs forever and nothing happens when adding a device (in this case a Fibaro motionsensor). Also when I want the Domoticz to "receive configuartion from other controller" it does nothing...

I think everything is in place to do a succesfull inclusion... but why is this not working? Could this be an OPen ZWave USB "bug/thing" in the latest update?

[sanderl]

No one recognizes this? I just had an update to 2.4025 and hoped this was solved. But still I am not able to include a zwave node.

[sanderl]

It seems this forum is pretty not-alive. Or is this a too hard qeustion or exotic setup? Install Domoticz on a NAS and insert a USB OpenZwave stick?

[raym]

I don't know much about your specific setup but I assume you have tried to exclude the device first? This is usually a good idea, even with new devices...

[sanderl]

I don't know much about your specific setup but I assume you have tried to exclude the device first? This is usually a good idea, even with new devices...

Yes off course thank you