GOCONTROL tested out

[venyv]

I picked up a GOCONTROL starter kit to see how well it worked last night. I had a few issues getting the stuff connected but once they were connected Domoticz picked the devices up.

The door sensor was by default was showing up as a light switch but that can be fixed. Once I got finish setting that up it always showed as Open and would never change status. Not really sure what the issue was with it and could not get it to work like a window/door sensor.

The Motion/Temp sensor worked half way. Domoticz only recognized the temp sensor and not the motion sensor. Another thing to note is that when you went to Devices in the menu it seemed to pick up the devices multiple devices for each sensor.

http://cl.ly/image/11040y1m1r1v

[gizmocuz]

Could you post a link to the manual/hardware?

The door sensor was by default was showing up as a light switch but that can be fixed

Seems this is a motion sensor, so yes, edit the switch and set the type to a motion sensor

some motion sensors does not send an 'off' command, if you edit the switch you can set the 'off delay' to 5 minutes (300 seconds) for instance

[venyv]

Yes it is a motion sensor but why do so many different devices come up for the one device?
That was my labeling for the GoControl Motion and GOCONTROL Temp.

I am able to see the temp sensor and I can get a reading for that but what kind of reading should I expect from the motion sensor if no one is in the room vs something or someone moving in the room?

[adsi4nt]

Not sure if you ever got this working. I am trying to get it setup and working without much luck. I am a newbie to Z-Wave and Domoticz and could use some help.

The link to the hardware is:
http://www.wink.com/downloads/help/goco ... sensor.pdf
&
http://www.wink.com/downloads/help/goco ... strobe.pdf

Any help or a can someone point me in a better direction for the GOControl devices? TIA

[mzy2240]

Did you eventually make it work as it should be?