Blockly script not working

[WilcoEHV]

Hi,
Anybody got a clue why the heater in the heater in the garage is not turning on?
Today all three conditions were met; temp below 8 degrees, solarpanels producing more than 1000 watts and heater was off.

Schermafbeelding 2025-01-10 194254.png (23.05 KiB) Viewed 147 times

[waltervl]

What is the trigger for the script? Should be device or time or All (not preferred).

[waltervl]

It seems you need the if-then block (without the blue gearwheel).
You used the else-if block....

[willemd]

Hi,
Anybody got a clue why the heater in the heater in the garage is not turning on?
Today all three conditions were met; temp below 8 degrees, solarpanels producing more than 1000 watts and heater was off.

Schermafbeelding 2025-01-10 194254.png

Your script tests for actuals > 1000 kWh while your mail mentions > 1000 Watts?
Which unit does your sensor show? Factor 1000?

[WilcoEHV]

Hi,
Thx for the replies!
I changed the if then block to one without gearwheel.
Hopefully this works!!

Triggers are in the script.
Solaredge reports watts and kwh (although i named it kWh).
I've got it on a different system where it's responding to watts.

[WilcoEHV]

Hi,
An update; the script is running as expected by now!
Thx for the help.