I have Honeywell and 2Gig Z-Wave Plus thermostats. When the setpoint is triggered and heating is engaged, the state indicator which is id 66, turns to 1.
zwave-js-ui will publish that to mqtt. But with the auto-discovery in domoticz, i have a) measured temp, b) setpoint temp, c) mode setting.
But I don't see anything in the event log, or anything indicated.
Is the state available somewhere in Domoticz?
Thermostat State
Moderators: leecollings, remb0
-
sivaci2754
- Posts: 2
- Joined: Wednesday 23 August 2023 13:35
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
-
waltervl
- Posts: 5910
- Joined: Monday 28 January 2019 18:48
- Target OS: Linux
- Domoticz version: 2024.7
- Location: NL
- Contact:
Re: Thermostat State
It could be that it became a number device and then it is in the setup section of the MQTT AD hardware gateway
https://www.domoticz.com/wiki/MQTT#MQTT ... very_Setup
https://www.domoticz.com/wiki/MQTT#MQTT ... very_Setup
Domoticz running on Udoo X86 (on Ubuntu)
Devices/plugins: ZigbeeforDomoticz (with Xiaomi, Ikea, Tuya devices), Nefit Easy, Midea Airco, Omnik Solar, Goodwe Solar
Devices/plugins: ZigbeeforDomoticz (with Xiaomi, Ikea, Tuya devices), Nefit Easy, Midea Airco, Omnik Solar, Goodwe Solar
Who is online
Users browsing this forum: No registered users and 1 guest