evofw3 on nanocul

For Evohome related questions in Domoticz

Moderator: leecollings

Post Reply
roblom
Posts: 402
Joined: Wednesday 26 February 2014 15:28
Target OS: Raspberry Pi / ODroid
Domoticz version:
Location: the Netherlands
Contact:

evofw3 on nanocul

Post by roblom »

I have a nanocul with evofw3 running on it. When I config it in Domoticz as a HGI80 I do get some devices but it are only boiler parameters and not the zone info I am looking for. What I mainly like to have is the heat demand percentages.
Does somebody know how I can get these heat demands in Domoticz?
roblom
Posts: 402
Joined: Wednesday 26 February 2014 15:28
Target OS: Raspberry Pi / ODroid
Domoticz version:
Location: the Netherlands
Contact:

Re: evofw3 on nanocul

Post by roblom »

I also get these errors.

Code: Select all

Error: evohome: unable to decode payload for command 10a0
roblom
Posts: 402
Joined: Wednesday 26 February 2014 15:28
Target OS: Raspberry Pi / ODroid
Domoticz version:
Location: the Netherlands
Contact:

Re: evofw3 on nanocul

Post by roblom »

Nobody?
roblom
Posts: 402
Joined: Wednesday 26 February 2014 15:28
Target OS: Raspberry Pi / ODroid
Domoticz version:
Location: the Netherlands
Contact:

Re: evofw3 on nanocul

Post by roblom »

For me the solution is here.
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests