Switching my Heatpump curve

[Derik]

Dzvents

Hard to get for me... But hopefully there are experts who can help me.

I have a heat pump with a Heishamon, the heishamon can control and read the heat pump via mqtt.
The heat pump has a heating curve, which I use to heat. The heating curve is controlled by heishamon via a thermostat setpoint sensor in Domoticz.

I am looking for a shift from +1 and -1 [ to +5 and -5] on my heating curve.
That shift should be able to switch in x time.
And at y temperature inside or z temperature outside.
This in increments of 1 at a time.

I've been fiddling with blockley with this for a while, but with this you can switch a thermostat setpoint.

Even if I've been busy with dz vents, but I really don't like it. My start script is worthless here.

Hopefully someone can help me with a script:

My sensors:

ScreenShot080.png (40.7 KiB) Viewed 465 times

ScreenShot079.png (35.8 KiB) Viewed 465 times

ScreenShot078.png (31.76 KiB) Viewed 465 times

[anno]

I am searching for something similar. I am complete useless when it comes to coding from nothing, i can read it, but start....

But i do have almost 50 temperature sensors and every room i want a (virtual) thermosstate. i have 30 groups.

and a heatpump, i also can't have it that all groups are closed.

[Derik]

Perhaps i get something in the near future.. from edterbak. They are looking for a nice option with dashbord.. auto shift.. hope when i get the beta. I can show