Neo Coolcam PIR ID=1036

[HarryB]

Hi there,

I bought some new Neo Coolcam Pir's, although they look exactly like the model PDZ-02, they have a different hardware.
They are not recognized and give ID=1036, tried to use the nas-pd02z.xml in manufactor_specific.xml but that does not work.
I see that they have motion, lux, temp & humidity now, humidity is a new feature.

BTW this is not the 7z series, got those finally operational.

I hope there is an XML file out there.

Raspberry 4
Aeotec Z-stick ZW-090Z
Domoticz 2022-2

[marshall]

I used nas-pd03z.xml and changed the id from 1031 to 1036.
Updating the parameters doesn't work but i edited the file and changed the default values to the values i want.
It sort of works, values differ from my older pirs (lux level much lower) but at least i can use it as a motion sensor.
Neo coolcam answered me this version is updated to zwave 700.
I asked them to send me an up to date xml.

[waltervl]

Perhaps you can check here: https://community.openhab.org/t/neo-coo ... /139255/14

[HarryB]

I also asked Coolcam for an updated XML but they told me that they don't have that.
It was also mentioned that this is the Z-Wave 700 chip.
In the mean time I have 3 of them and can't really configure them.

Wish somebody could create a working XML for this device.
There is also a temperature and humidity sensor in this one.

@walterevl I saw that link already, but it is about Open Hab and the XML file is not for Domoticz.

[marshall]

This XML sort of works

[HarryB]

This XML is not working either, you can't config the parameters.
I hope it will work sooner or later in the new Z-wave zwave2mqtt.
This is a new device with more functionality, I would think it is already used somewhere.

[marshall]

Open the file and edit the value to what you want it to be.