OTGW+NodeMCU: Only 4 devices appear!:-(

For OpenTherm-gateway related questions in Domoticz

Moderator: leecollings

Post Reply
McKolders
Posts: 1
Joined: Thursday 23 May 2019 23:34
Target OS: Windows
Domoticz version:
Contact:

OTGW+NodeMCU: Only 4 devices appear!:-(

Post by McKolders »

Hi!

I've been playing with my OTGW device for quite a few hours now, but whatever I try, only four devices appear in Domoticz: GPIOAStatusIsHigh, GPIOBStatusIsHigh, GPIOAPulledToGround & GPIOBPulledToGround.

The hardware: a Nodo-shop OTGW with a NodeMCU for network access. Followed the manual in detail, configured everything as mentioned.

When I run otmonitor (after a hardware reset of the OTGW as Domoticz "kills" otmonitor) it shows data, so my setup seems to work. However when I add the hardware in Domoticz, it only adds four devices, not the 30-something devices I should get. I've read through the topics here, tried them all but so far no luck.

Any help would be greatly appreciated!

Log:
Domoticz log 23-5-2019.txt
(5.75 KiB) Downloaded 122 times

.Michiel.
Vreak77
Posts: 5
Joined: Saturday 24 December 2022 13:50
Target OS: NAS (Synology & others)
Domoticz version: 3.8153
Location: NL
Contact:

Re: OTGW+NodeMCU: Only 4 devices appear!:-(

Post by Vreak77 »

Hi, just a question, as I do encounter a simular kind of issue. Did you allready found a sollution?
Difference on my side is that i do see values in the log, where you get error logs...
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests