Domoticz 2022.1
Hi!
I control my somfy blinds with the somfy remote control as well as using the rfxcom RX/TX.
Out of the blue it was not possible anymore to control the blinds using Domoticz.
I did a reset on the somfy blinds. Readjusted top and bottom postion etc. using the somfy remote control Therafter I created new controls for the blinds using the RFXmngr.
So far so good. I was able to control the blinds again from Domoticz. Both manual as well as using a script.
But after a few days again it was no longer possible to control the blinds using Domoticz. Using the Domoticz control a blind just moved just a little and than no control was possible. No Up, No Dwn and No Stop. Same for all other blinds.
I am stuck.
Any suggestions?
TIA
-Bart
somfy blinds stop working. why?
Moderator: leecollings
-
- Posts: 365
- Joined: Sunday 03 July 2016 16:16
- Target OS: Raspberry Pi / ODroid
- Domoticz version: V2024.7
- Location: Netherlands
- Contact:
somfy blinds stop working. why?
Raspberry pi 3b
Arduino
KAKU
RfxCom
Zwave2MQTT
OTGW
Chinese sensors temp (Dallas),movement
Tasmota
Esp8266 / 32 espeasy
Zigbee2MQTT
Arduino
KAKU
RfxCom
Zwave2MQTT
OTGW
Chinese sensors temp (Dallas),movement
Tasmota
Esp8266 / 32 espeasy
Zigbee2MQTT
-
- Posts: 365
- Joined: Sunday 03 July 2016 16:16
- Target OS: Raspberry Pi / ODroid
- Domoticz version: V2024.7
- Location: Netherlands
- Contact:
Re: somfy blinds stop working. why?
Update:
It seems a now-and-then error.
Sometimes the error is there. Another time all works as expected.
It seems a now-and-then error.
Sometimes the error is there. Another time all works as expected.
Raspberry pi 3b
Arduino
KAKU
RfxCom
Zwave2MQTT
OTGW
Chinese sensors temp (Dallas),movement
Tasmota
Esp8266 / 32 espeasy
Zigbee2MQTT
Arduino
KAKU
RfxCom
Zwave2MQTT
OTGW
Chinese sensors temp (Dallas),movement
Tasmota
Esp8266 / 32 espeasy
Zigbee2MQTT
Who is online
Users browsing this forum: No registered users and 1 guest