RFLink - Ventilation/Hood SF-01 Recieving but not transmitting

[Wolly76]

Hi All,

In our kitchen we have a Wave Design SF-01 Ventilation/Hood that comes with a RF 433 remote control.
I'm able to receive the messages from the remote control (20;5B;Bosch;ID=6e43;SWITCH=1;CMD=UP;) but I'm not able to send those using RFLink. According to the support list both directions should be supported.

What could be the reason that it doesn't work yet? Other devices do work. Is there a solution? Do I need to send a different code?

Many thanks in advance.
Regards,
JW

[erem]

you can try and send the message from rflinkloader to rule out the hardware and see if it works that way.

send 10;Bosch;6e43;1;UP;

if that works, next step is checking what domoticz sends to rflink.
i use wireshark to debug usb.

[Wolly76]

hi erem,

that's exactly what I've tried but without success. I don't understand why.
Might it be that an additional tag is send over RF433 that is not recognized by the RFLink receiver?

[erem]

that puts the problem squarely in the rflink arena.

i suggest you put the problem in the rflink section of the espeasy forum for better response

https://www.letscontrolit.com/forum/vie ... 62d5a77be8

or email the author at [email protected].

sorry that i cannot help further...