I have a blockly using 2 conditions:
- a switch condition
- a time condition.
- trigger on switch (not all to avoid too many checks)
If switch is on and time > 22:00 the action should start
This event does not trigger. Can't figure out why
Event triggering
Moderator: leecollings
-
- Posts: 5
- Joined: Thursday 15 November 2018 9:56
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Event triggering
- Attachments
-
- event.jpg (43.52 KiB) Viewed 532 times
-
- Posts: 265
- Joined: Monday 05 February 2018 8:42
- Target OS: Raspberry Pi / ODroid
- Domoticz version: 12467
- Location: Netherlands, near Haarlem
- Contact:
Re: Event triggering
Are you sure that deur bijkeuken is open is the right trigger? Should it not be On of Off?
Domoticz 2020.1 (12230) on Raspberry Pi 3B with Raspian Buster. Besides Domoticz, Rpi is running Pi-Hole.
-
- Posts: 109
- Joined: Tuesday 02 October 2018 20:52
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: Event triggering
It's good to check the right state indeed. Next to that you're time locks should be with an and I guess. Because now one of them is always true.
-
- Posts: 265
- Joined: Monday 05 February 2018 8:42
- Target OS: Raspberry Pi / ODroid
- Domoticz version: 12467
- Location: Netherlands, near Haarlem
- Contact:
Re: Event triggering
@Wouterlet, Time can never be > then Sunset And < then Sunrise. That will never happen. Because > sunset is from sunset till 0:00 and before sunset is from 0;00 till sunrise. If I'm not mistaken. So OR is okay here.
Domoticz 2020.1 (12230) on Raspberry Pi 3B with Raspian Buster. Besides Domoticz, Rpi is running Pi-Hole.
-
- Posts: 109
- Joined: Tuesday 02 October 2018 20:52
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: Event triggering
I'm sorry you're right. I switched them around. That part must be fine
Who is online
Users browsing this forum: No registered users and 1 guest