Adjust setpoint without triggering device change

[thorazine]

How can I update setpoint value without triggering device change event?

I tried CommandArray['UpdateDevice'] - it works with Selector Switch etc. but when I try to use it to adjust setpoint value it immediately triggers device change.

Also is there a way to get info about current state of nvalue fof Selector switch?
Probably there is some easy way to do this...

Thanks for any help with this

[waaren]

Also is there a way to get info about current state of nvalue fof Selector switch?
Probably there is some easy way to do this...

Are you looking for a manual- or a script solution ?

[thorazine]

I try to do this from LUA script.