Bathroom venting Blocky

[marktn]

Hi,

I have made a blocky for my bathroom venting, it works! But it only is looping.
When the switch is on, it give's every minute an ON signal.

Is there a way to prevent this?

Code: Select all

 2020-02-02 11:12:46.907 Error: (Zigate) Command: 0x0092:On/Off failed on relay afzuiging badkamer
2020-02-02 11:12:46.907 Error: (Zigate) - Device: Badkamer ventilatie NwkID: 25dd IEEE: 00158d0003f05121
2020-02-02 11:12:46.907 Error: (Zigate) - Code: d4 Status: Unicast frame does not have a route available but it is buffered for automatic resend
2020-02-02 11:13:32.307 Error: (Zigate) Command: 0x0092:On/Off failed on relay afzuiging badkamer

[peerkersezuuker]

Hello,
I would suggest to check first if "Badkamer Ventilatie" is already on after your humidity check.
If so don't do anything, if not switch it on

Regards
Peer

[marktn]

Hello,
I would suggest to check first if "Badkamer Ventilatie" is already on after your humidity check.
If so don't do anything, if not switch it on

Regards
Peer

Hello,
Thanks for helping. But how to "If so don't do anything" ?

Mark

[mrf68]

Add to the first IF statement: AND badkamer ventilatie = Off