I bought a "Vision Security ZG8101 Garage Door Detector". I have included it and the following devices are detected:
00011F00 1 Sensor Light/Switch Switch Off
00011F35 1 Home Security Light/Switch Switch Off
00011F35 7 Alarm Type: Home Security 7 General Alarm Event: 0x00 (0)
When I tilt the sensor I can see the following in the log:
2019-08-18 00:53:02.306 (Z-Stick gen5) General/Alarm (Alarm Type: Home Security 7 (0x07))
2019-08-18 00:53:02.308 (Z-Stick gen5) Light/Switch (Home Security)
2019-08-18 00:53:02.305 Status: OpenZWave: Alarm received (Home Security: Intrusion at Unknown Location)
2019-08-18 00:53:07.306 (Z-Stick gen5) General/Alarm (Alarm Type: Home Security 7 (0x07))
2019-08-18 00:53:07.308 (Z-Stick gen5) Light/Switch (Home Security)
2019-08-18 00:53:07.305 Status: OpenZWave: Alarm received (Home Security: Clear)
But the "Sensor" never seems to switch state (on/off) it is always set to "off".
I'm not sure if I'm doing something wrong. Anyone else that has a zg8180? Please help
Regards/S