Aeotec ZW120 Door contact

[Solderbro]

Maybe a stupid basic question, i added two ZW120 door sensors to my domoticz.

They add 4 devices, shown here

Aeotech C5 00001700 1 Eingang Türsensor Light/Switch Switch Open - -
Aeotech C5 00001735 1 Flur Türkontakt Burglar Light/Switch Switch Off - -
Aeotech C5 00001734 6 Haustür: Access Control 6 (0x06) General Alarm Event: 0x17 (23) - -
Aeotech C5 00001735 7 Flur Türkontakt: Burglar 7 (0x07) General Alarm Event: 0x00 (0) - -

Both switches can be added and they appear on the "Switches" page in domoticz
Both 'feedback' devices can be added, but they don't appear on any page and so they cannot be used in any way

Has anyone an idea, how to make the feedback appear somewhere on the pages?
Solderbro

[Lebo2d9]

Are they in the device list listed as "used" or "not used"?

[Solderbro]

Now we can go on, have bought Neo Coolcam Doorsensors to check if something else is bugged, but they do their turn.

First the Aeotec sight in OZWCP
52 L Routing Slave Notification Sensor Aeotec Doorsens 0 15:16:41 ProtocolInfo

No idea why they are routing slaves, they run on battery but there is no battery device in domoticz for it.

This is their node view in hardware:
052 (0x34) Aeotec Doorsensor Test 0x0000 0x0000 2019-07-20 15:16:41 Nein

Here is the protocol:
2019-07-20 15:11:42.121 Status: OpenZWave: New Node added. HomeID: 4184065801, NodeID: 52 (0x34)

At the moment i would suggest to buy the cheaper Coolcams, they are supported.