New device - TZWP-102, PR created

[Flopp]

Anyone tested this yet?

http://download.telldus.com/Manuals/Tel ... manual.pdf

[Flopp]

I now finally bought this.
I set Domoticz to Include Node and then plug the device to a socket and it automatically was added, no button pressed
Domoticz see this

Code: Select all

Telldus_Plugg	Telldus Unknown: type=0003, id=0003	Telldus	0x0003	0x0003

I can control it On/Off and see Voltage, Amp, Watts, kWh, so far everything is perfect.

What I cannot do is to configure it, I think this is because there is no XML file for this device.

Is there any place where to read how to create a XML for a Z-wave device?

[Flopp]

I have now added all information for this device. Pretty easy just by looking how other devices was setup.
Created 2 Pull requests.
https://github.com/domoticz/domoticz/pull/2493

[Flopp]

I have now tried little more and it seems that everything is working until you try to send new settings to the device

[Flopp]

I had made a mistake in TZWP-102.xml, that was it was not working to send new settings to device.

Everything is working OK now.

PR accepted by OpenZwave and merged