Problems with controlling the setpoint

For OpenTherm-gateway related questions in Domoticz

Moderator: leecollings

Post Reply
remco770
Posts: 3
Joined: Sunday 12 March 2017 20:49
Target OS: Linux
Domoticz version:
Contact:

Problems with controlling the setpoint

Post by remco770 »

I've a OTGW connected through USB at my Domoticz environment (RPI)
When I control the setpoint, most of the times the setpoint isn't going trough. Sometimes it works perfectly

Remeha iSense thermostat (RF version)
OTGW through Nodo Shop

Could someone help me out?
pfwolbers
Posts: 11
Joined: Monday 05 January 2015 19:58
Target OS: Raspberry Pi / ODroid
Domoticz version: beta
Location: the netherlands
Contact:

Re: Problems with controlling the setpoint

Post by pfwolbers »

Check your LOG to see or the gateway gives any errors.
Ron
Posts: 82
Joined: Friday 27 December 2013 23:29
Target OS: Raspberry Pi / ODroid
Domoticz version: 2.2284
Location: Nederland, Den Bosch
Contact:

Re: Problems with controlling the setpoint

Post by Ron »

I found out that only 1 degree settings works, not 0,5 degree.
So if the roomtemperature setting is 20 degree i can not change it to 20,5 (I can but it doesn't work) but changing it to 21 works fine.
Also you have to be patiënt, of takes some time untill the thermostat shows the changed temperature.
In the log you can see the change imediatly.
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests