pool temperature sensor TFA 30.3216.20

[Dirkie]

I hava a pool temperature sensor TFA 30.3216.20 installed. At my devices it is shown as a TFA 30.3133 with a temperature of 0 degrees celcius and it is actualy 27 at this moment

Is there a method to change the reading so the correct values are shown?

Devices: Synology diskstation; RFXtrx433

[Dennist1985]

Click the temperature tab.
Then click edit from your pool sensor and type 27 in the adjustment box.
Now it's always showing 27 degrees more then what he measuring.

[Dirkie]

I've tried this already but the temperature doesn'nt change in domoticz when it changes in the pool...

[Derik]

Show some screendumps...

[Dirkie]

this is how the sensor is recognized by Domoticz

tfa.PNG (5.74 KiB) Viewed 5450 times

as I wrote eralier, donoticz thinks it is a 30.3133 insted of a 30.3216.20

[ervine]

I have the same unit, also recognized as a 3133. In my case however temp readings work.

[b_weijenberg]

The 30.3216.20 for the TFA 30.3056.10 is supported in Ext2 firmware version 1007 for the RFXtrx433E.
Enable the Oregon protocol for this TFA sensor!

On request a Type1 firmware for the RFXtrx433 can be provided by RFXCOM.

[Derik]

mmm did have last year this sensor working...
Now the summer is here..
I try to add the sensor again.
See the value on the screen.
New battery
pus the tx button servel time.
Replace new battery..
Set the good protocol...

No sensor...

Bert where do i go wrong??
Think to much protocols enabled....
Only witch 2 hate each other?

[b_weijenberg]

check with RFXmngr if the sensor is received with only TFA enabled