Hello!
I have an alarm system from konig. RFLink picks up the devices but I have a problem with the motion sensors. I have put one in the garage. When motion is detected it sends on. However I have another motionsensor that is detected as the same device as the garage sensor but sends an off-signal instead?
Motion sensor problem
Moderators: leecollings, Stuntteam
-
Stuntteam
- Posts: 399
- Joined: Wednesday 06 May 2015 16:39
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: Motion sensor problem
Make a debug log as explained here:
http://www.nemcon.nl/blog2/development
and mail the log to [email protected] so we can correct it.
http://www.nemcon.nl/blog2/development
and mail the log to [email protected] so we can correct it.
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic RFLink Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Introduction: http://www.nemcon.nl/blog2/
Generic RFLink Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
-
Jazzle
- Posts: 21
- Joined: Friday 31 March 2017 13:16
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: Motion sensor problem
Olskar, is your alarm system now working with Domoticz? And which system is it? SAS-alarm100/110/120?
Who is online
Users browsing this forum: No registered users and 1 guest