RFXCOM WIFI

[Moulins44119]

Hello,
I’m not very tech-savvy, which is why I’m reaching out for some help.
My RFXCOM, which was connected to my Raspberry Pi 3 for Domoticz, has stopped working.
I’ve received a new RFX-433EMC, but for the past two days, I’ve been struggling to get my weather sensors to show up.
The RFXCOM is properly connected to the Wi-Fi—my Raspberry Pi indicates that the signal is excellent. However, even though I’ve enabled the option to accept new devices in Domoticz, nothing is appearing.
I have the RFXCOM’s IP address (192.168.1.100) and port (10001). I’ve set up a hardware device in Domoticz using the "RFXCOM - RFXtrx shared over LAN interface" type.
For the time being, I’m powering it with my laboratory power supply at 5.36V, and it’s drawing 0.05 A.
Where am I going wrong? Thanks in advance.

[jvdz]

@Moulins44119, please use English in this forum.