Request Orcon functionality in Domoticz

[homeJLB]

I've found an Orcon RF15 remote control unit, and would like to interface that to Domoticz. Purpose is to switch my existing ventilation unit with it.
So all I need is a way to receive the signals sent by the remote control unit, and hand them to domoticz somehow. Node Red/MQTT sounds fine.

Would this be possible?

Yes, when you have a RFXcom868 connected and correctly configured in domoticz.
Then when you press the RF15 the switch is detected and then you can make a automation based on the status off that switch.

kind Regards

[manjh]

I use an RFLink with 433 support to handle my KlikAanKlikUit modules. But this version of RFLink does not support 868.3.

So I am looking for a relatively cheap way to receive the signals from the remote control unit...

[manjh]

I've found an Orcon RF15 remote control unit, and would like to interface that to Domoticz. Purpose is to switch my existing ventilation unit with it.
So all I need is a way to receive the signals sent by the remote control unit, and hand them to domoticz somehow. Node Red/MQTT sounds fine.

Would this be possible?

Just to clarify: I only have the RF15 remote controller, the one with the six buttons. I donot own or plan to purchase any other Orcon devices.
The one and only thing I would like to establish, is to receive the signals from the remote controller and feed them into Domoticz.
Preferably for a small amount of €€€...

[homeJLB]

Yes thats what I suggest, Only for the moment there are only 4 buttons working.

and in the actions you can make a command to execute

Kind Regards

[manjh]

Yes thats what I suggest, Only for the moment there are only 4 buttons working.

and in the actions you can make a command to execute

Kind Regards

OK, but you mention "when you have RFXcom"in one of your previous posts... I don't have one, only an RFLink, and not supporting this frequency!
So I am looking for a cheap bit of hardware to support 868!