I finally found a (tricky) solution! It uses RFXcmd . I first used Windows and RFXMngr (available on the RFXCOM official webiste), to receive, decode and clean the raw packets sent by my remote. I created a clean .txt file as explained in the user guide (page 50) and then used RFXMngr to transmit ...

Okay I eventually got it to work. What I did: I first included the sensor, bringing it near the controller. Then I brought it near the repeater (the one that will be the closest one to the sensor once at its final place). This way, the sensor was in the range of both the controller and the repeater ...

Yes I did, but as the smoke sensor is asleep and, and even if I triple-click the B button, it still appears as asleep in Domoticz, so it can't receive the heal command...

Hi I have a problem with my Z-Wave Fibaro Smoke Sensor (FGSS-001). The sensor is located in my garage, far away from my controller, but close to a Fibaro wall plug (that acts as a Z-Wave repeater). My main controller is an Aeotec Z-Stick. The problem is that the sensor, once put in the garage, does ...

Hi, My gate remote is not recognized by the RFXtrx433XL and Domoticz. However, with undec_on in RFXMngr on Windows, I managed to capture the message sent by the remote, to put it in a .txt and to repeat it with the RFXCom, using RAW transmit in RFXMngr, what successfully opened my gate. Now my ...