Search found 6 matches
- Monday 17 September 2018 16:34
- Forum: Z-Wave
- Topic: device dies for the second time
- Replies: 0
- Views: 337
device dies for the second time
A Qubino ZMNHND1 Flush 1D relay+ module dies after a couple of weeks. It shows the red dot with the exclamation mark in the hardware tab. I have had the same problem a month ago and replaced the node. I found it hard to believe that two equal devices in the same location (physically) stops working ...
- Thursday 06 September 2018 16:00
- Forum: Heating/cooling
- Topic: HG180 no firmware found
- Replies: 7
- Views: 2663
- Thursday 06 September 2018 15:56
- Forum: Heating/cooling
- Topic: HG180 no firmware found
- Replies: 7
- Views: 2663
Re: HG180 no firmware found
It Works!! Thank you very much. I think more people will benefit from this post. [ 16.081456] usb 1-1.1.2: reset full-speed USB device number 5 using dwc_otg [ 16.217111] usb 1-1.1.2: device firmware changed [ 16.217388] usb 1-1.1.2: USB disconnect, device number 5 [ 16.311444] usb 1-1.1.2: new full ...
- Wednesday 05 September 2018 20:06
- Forum: Heating/cooling
- Topic: HG180 no firmware found
- Replies: 7
- Views: 2663
Re: HG180 no firmware found
I found a file ti_3410.fw but I don't know what to do with it. I looked for a folder "modules" in etc (etc/modules) but there was no folder only a modules file. I suppose my lack of Unix knowledge is now showing. I think I've found the proper file but don't know how to install it. All other firmware ...
- Tuesday 04 September 2018 15:43
- Forum: Heating/cooling
- Topic: HG180 no firmware found
- Replies: 7
- Views: 2663
HG180 no firmware found
I have found several postings for this issue but nobody seems to have the solution. I followed the Evohome installation instruction (wiki) thoroughly. But got stuck on the firmware. Then check your kernel messages with dmesg Depending on your distribution you may need to supply a firmware file or ...
- Tuesday 04 September 2018 15:14
- Forum: Heating/cooling
- Topic: HGI80 install on a Pi - getting Lost
- Replies: 5
- Views: 2678
Re: HGI80 install on a Pi - getting Lost
Have you solved the problem? I have the same problems. I can't get it up and running