Hello Everyone, I'm planning quite big installation of Xiaomi switches in my house, around 30 switch all together. I'm a little bit worried - constantly changing firmware on Gateway might break things up between all the devices and Domoticz... what do you think, is there a reason to be worried? I ...

Let’s say you have your heating desired temperature set to 21º, and the last temperature reported by the sensor is 20.9, so the heater is on. Then, at a particular moment in time due to the current climate conditions, it takes 5 minutes to increase 0.1 degree, so to reach 20 degrees, it only takes 5 ...

vti5 wrote:I think later they recall this news as a mistake. They plan to implement this later this year. (not 100% sure)

There is something here but not precise given date for new firmware release.
https://www.wired.com/story/ikea-smart-home/amp


Sent from my iPhone using Tapatalk

Is some way to count Atmospheric pressure in Domoticz in hPa/kPa units ? Now is supported Xiaomi Aqara Temperature sensor , and it is showing units in bar , but if I want to show it in kPa , I think it must be counted from height about sea level . https://image.prntscr.com/image ...

AQARA AC-CONTROLLER I tried to add a temp&humid sensor previously connected to my gateway and it went well but sensor was disconnected from gateway (cannot be used by both devices at the same time I guess) I think this new kind of gateway could be easily added and managed by domoticz, I would be ...