The issue has been resolved by exchanging the sensor for a new one. This one reacts as described on the motion sensor and burglar state.

Thank you all for your assistance, because of this Aeotec concluded quickly it was a faulthy sensor.

Kind regards

Yeah i noticed, but then the burglar sensor must change from 0x03 (motion) to 0x00 (idle state) and to 0x07 (vibration) if i pick it up? It never changes back to state 0x00 and/or 0x03 (not registrering motion).

About the groups. I canceled that action, just needed the screenshot. Controller is ...

I started the whole system again, and suddenly the motion sensor worked for one time. Hereby the log. Sensor is: MS-Motion, i received a pushover notification when it turned off again. Didnt turn on afterwards though :(

Below also the startup log. The burglar event is now 0x00, but doesnt change to ...

I've opened a ticket at Aeotec giving all the details and this topic. I hope they have a solution for this. Keep this topic posted..

Updated to beta, nothing changed except burglar status is not 3 but 0x03 now, also the following error in log:

2017-03-24 14:40:51.497 PluginSystem: Failed dynamic library load, install the latest libpython3.x library that is available for your platform.

Tested the motion sensor... working good here
Make sure you enabled accept new hardware, you should get a new alarm sensor (burglar = 7)
For a explanation of the values see this excellent post, or see the "technical" manual..

Also the switch labeled "sensor" with the ID ending on '00' get's ON for ...

i'am not sure of this issue is related: https://github.com/domoticz/domoticz/issues/1107

When i revert back to stable using: ./updaterelease, the data for the Alarm Type: Burglar 7 (0x07) says 3, now instead of 0x03

schulpr wrote:I have them several months and they work flawlessly. Also the motion part.


Verzonden vanaf mijn iPad met Tapatalk

As in the burglar alarm changes state of event?

v1.07

Thanks! I don't see to see your controller in the OZWCP, why is it missing? When i remove the sensor from Domoticz it doenst show the removal in the OZWCP which makes it out of sync (sensor responds for certain events but reports on old name).

I did a reset of the controller through the zensys ...

Thanks! i changed my settings to the same but still no luck. Can you post a screenshot of the /ozwcp/cp.html > MultiSensor > Current values for me? I have no clue what can be the issue/difference :(

And how did you add this sensor? when i add it securely after a hard reset of the controller, i saw ...

Below picture seems wrong, sensor is off, what ever i do i dont get it to ON. Any suggestions?

There has been a change to the way the sensors work. The device you need to note is shown as your device '75'. The Aeotec Multisensor 6 which also now appears as an "Alarm Type: Burglar 7 (0x07)". The motion & vibration detection is working as follows:
In a 'normal undisturbed state', it reports ...

Solution
The issue has been resolved by exchanging the sensor for a new one. This one reacts as described on the motion sensor and burglar state.

Thank you all for your assistance, because of this Aeotec concluded quickly it was a faulthy sensor.

Kind regards

Problem state

Versions used ...