Under devices I am showing 6 devices\switches that are tied to this device. However only the top big\wide button works. The others dont do anything and if I try to use the button inside domoticz I get this error "Error sending switch command, check device/hardware !"

Did you ever get this to work?

I found this to help get the proper link and I can pull it up in a browser but Domoticz does not see it.
https://www.ispyconnect.com/man.aspx?n=Amcrest#

Reply from Fortrezz It seems that DomoticZ is able to see the 2 relay endpoints, but not the signal inputs. Unfortunately, we are not familiar with this brand and have not tested independently. Typically, the problem we see "in general" is that the Z-wave controller thinks our signal inputs are the ...

I have also configured a mimo for controlling a garage door. I went with the mimo2 instead of the mimolight. However I am having issues with magnetic sensor being shown in domotic. I created another post to hopefully get some help. http://www.domoticz.com/forum/viewtopic.php?f=28&t=16656&p=124187 ...

I would also like a different switch type. Looking for a momentary switch instead of an off\on switch.

I am using the mimo2 with domoticZ. The device shows up with the following devices. None of witch seem to say if the door is open or closed with a magnetic sensor. The indicator light on the board comes on when the door is open. All the switches control one of the garage doors. I have listed the ...